Citroen Xantia

since 1993 of release

Repair and car operation

Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
- Power shafts
   Removal and installation of power shafts
   Replacement of rubber protective covers of CV JOINTS of power shafts
   Major maintenance of power shafts - the general information
   Replacement of the intermediate bearing of the right power shaft
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes

With Soap2day, you can enjoy on-demand streaming at your fingertips. ad6e8668

Power shafts



Greasing type

To use only the greasing delivered complete with new protective covers (hinges are filled by greasing at manufacturer and загерметизированы)

Efforts of a tightening of carving connections, Nanometer

Nut of fastening of a power shaft


Nuts of bolts of fastening of the intermediate bearing of the right power shaft


Nut of the bottom spherical support of a forward suspension bracket


Bolts of fastening of wheels


General information

Rotation from differential of the main transfer of transmission to driving wheels is transferred by means of two all-metal power shafts having various length.

Each of power shafts since the external end is equipped with the pin equipped with shlitsa entered into gearing with shlitsa of stupichny assemblies of driving wheels of the car. On the end of an external pin the carving under a big fixing nut by means of which the shaft fastens in a nave is cut. Internal pins of shaft are also equipped with the shlitsa entered into gearing with shlitsa of lateral gear wheels of differential.

Since both ends of each shaft hinges of equal angular speeds (CV JOINT), providing uniform transfer of a torque from the main transfer are located to driving wheels at any changes of provision of components of a suspension bracket. Internal CV JOINTS represent tripodny assemblies, external have a separator and ball design.

Power shafts

1 — Internal CV JOINTS
2 — Protective covers
3 — External CV JOINTS

4 — Shlitsa
5 — the Carving

In view of the increased length of the right power shaft its internal CV JOINT is located approximately on a half of length of a shaft (see an illustration Power shafts) which average part fastens placed in an arm of a back support of the power unit the intermediate bearing. The internal end of a shaft is passed in the bearing preventing cross-section movement of internal section of assembly, and then in an external part of the internal CV JOINT.