Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
- Routine maintenance
   + Weekly checks
   + Routine maintenance of the car - petrol models
   - Routine maintenance of the car - diesel models
      Regular service
      Replacement of impellent oil and oil filter
      Check of a condition of hoses, and identification of sources of leaks
      Water removal from the fuel filter
      Check of adjustment of coupling
      Check of level of ATF
      Suspension bracket and steering drive
      Check of a condition of protective covers of power shafts
      Reading of memory of the block of self-diagnostics
      Replacement of the dust removal filter (model with To/in)
      Check of a condition of a coolant of central air of air
      Check and adjustment of turns of idling and prevention spontaneous останова engine
      Check of serviceability of functioning of systems of decrease in toxicity of the fulfilled gases
      Check of a condition and replacement of a belt of a drive of auxiliary units
      Greasing of the mechanism of a drive of switching off of coupling
      Check of serviceability of functioning and adjustment of the parking brake
      Trial runs
      Replacement of the fuel filter
      AT transmission liquid replacement
      Check of a condition of blocks of brake mechanisms of lobbies and back wheels
      Greasing of locks and loops
      Replacement of hydraulic LHM liquid and returnable filter
      Replacement of a filtering element of an air purifier
      Check of level of transmission oil (model with RKPP)
      Check of a condition of brake supports, disks and hydraulic hoses
      Replacement of a belt of a drive of GRM
      Replacement of cooling liquid
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes


ad6e8668

Routine maintenance of the car - diesel models

Schedule of routine maintenance

Intervals of routine maintenance of the car offered in the present section are calculated on independent performance of all procedures by the owner of a vehicle. Duration of intervals was defined proceeding from a condition of daily operation of the car. Constantly to support a vehicle in the dives of a form some of procedures at will of the owner can be carried out in more intensive mode. Originators of the real Management are sure that receiving from the power unit of the car and its other knots and systems of the maximum return can achieve only under condition of a conscientious attitude of the owner to care of the vehicle. It is worth to remember as well about maintenance of a trade dress of the car on a case of its resale.

At car operation in the conditions of strongly dusty district, frequent towage of the trailer or continuous moving in an intense city cycle, intervals of performance of procedures of routine maintenance should be whenever possible reduced to a minimum.

Servicing of a new vehicle should be made in the conditions of a workshop service center of the trade mission of the company manufacturer of the car in order to avoid violation of factory guarantee certificates.

Through each 400 km (250 miles) run or once a week

•  See. Weekly checks.

Through each 10 000 km (6000 miles) run or times in 12 months (that will come earlier)

•  Make replacement of impellent oil and the oil filter (see. Replacement of impellent oil and oil filter).
•  Check all components located in an impellent compartment and hoses on existence of traces of leaks (see. Check of a condition of hoses, and identification of sources of leaks).
•  Merge water from the fuel filter (see. Water removal from the fuel filter).
•  Make check/adjustment of height of a pedal of coupling (see. Check of adjustment of coupling).
•  Check ATF level, in case of need make the corresponding adjustment (see. Check of level of ATF).
•  Check a condition and reliability of fastening of components of a suspension bracket and a steering drive (see. Suspension bracket and steering drive).
•  Check a condition of rubber protective covers of power shafts (see. Check of a condition of protective covers of power shafts).
•  Make the data read-out, brought in memory of the block of self-diagnostics (see. Reading of memory of the block of self-diagnostics).
•  On the models equipped To/in, make replacement of the dust removal filter (see. Replacement of the dust removal filter (model with To/in)).

Through each 20 000 km (12 000 miles) run

In addition to the checks listed in the previous subsection:
•  At the corresponding complete set check a condition of a coolant of central air of air (see. Check of a condition of a coolant of central air of air).
•  Check installations of turns of idling and turns of prevention spontaneous останова the engine (see. Check and adjustment of turns of idling and prevention spontaneous останова engine).
•  Check a condition of components and connecting hoses of system of decrease in toxicity of the fulfilled gases (see. Check of serviceability of functioning of systems of decrease in toxicity of the fulfilled gases).
•  Check a condition of a belt of a drive of auxiliary units, in case of need make its replacement (see. Check of a condition and replacement of a belt of a drive of auxiliary units).
•  Grease the mechanism of management with a coupling drive (see. Greasing of the mechanism of a drive of switching off of coupling).
•  Check serviceability of functioning of the parking brake (see. Check of serviceability of functioning and adjustment of the parking brake).
•  Make trial runs of the car (see. Trial runs).

Through each 30 000 km (18 000 miles) run

In addition to the checks listed in the previous subsection:
•  Make replacement of the fuel filter (see. Replacement of the fuel filter).
•  Make ATF replacement (see. AT transmission liquid replacement).
•  Check a condition of blocks/boots of brake mechanisms of lobbies and back wheels, in case of need make replacement (see. Check of a condition of blocks of brake mechanisms of lobbies and back wheels).

Through each 60 000 km (36 000 miles) run

•  Make check of a condition and, in case of need, replacement of a belt of a drive of auxiliary units on models with manual adjustment of a tension of a belt (see. Check of a condition and replacement of a belt of a drive of auxiliary units).
•  Make replacement of hydraulic LHM liquid and returnable filters (see. Replacement of hydraulic LHM liquid and returnable filter).
•  Make replacement of the air filter (see. Replacement of a filtering element of an air purifier).
•  Check RKPP transmission oil level, in case of need make the corresponding adjustment (see. Check of level of transmission oil (model with RKPP)).
•  Check a condition of brake supports, disks and hydraulic hoses (see. Check of a condition of brake supports, disks and hydraulic hoses).
•  Make replacement of a belt of a drive of GRM (see. Replacement of a belt of a drive of GRM) *.
•  Grease all locks and loops (see. Greasing of locks and loops).

In spite of the fact that according to the schedule of routine maintenance replacement of a gas-distributing belt should be made through each 120 000 km (72 000 miles) run, originators of the real Management recommend to cut this interval by half for the cars maintained in the conditions of increased intensity. Remember that the damages of the engine connected with an exit of a belt out of operation in operating time can lead to incommensurably big expenses!

Through each 120 000 km (72 000 miles) run

In addition to the checks listed in the previous subsection:
•  Make replacement of a belt of a drive of GRM (see. Replacement of a belt of a drive of GRM).
•  Make check of a condition and, in case of need, replacement of a belt of a drive of auxiliary units on models with automatic adjustment of a tension of a belt (see. Check of a condition and replacement of a belt of a drive of auxiliary units).

Time in two years (regardless of run size)

•  Make replacement of cooling liquid (see. Replacement of cooling liquid).

Type of an impellent compartment of the Xantia Turbo Diesel models

1 — the Preliminary fuel pump
2 — a nozzle Tube
3 — the air lever going to a turbokompressor
4 — the Casing of the fuel filter
5 — the Indicator of level of hydraulic LHM liquid
6 — the Tank of hydraulic LHM liquid
7 — the Cover of the assembly block of safety locks/relay
8 — the Battery
9 — an air purifier Casing

10 — Equipped measuring shchupy a cover of a jellied mouth of impellent oil
11 — the Top radiatorny hose
12 — Maslookhladitel with the filter
13 — ТНВД
14 — the Generator
15 — the Belt of a drive of auxiliary units
16 — the Cover of a jellied mouth of a broad tank of system of cooling
17 — the Cover of the tank of liquid of washing wind/back glasses
18 — the Receiver of the tank of hydraulic LHM liquid

The bottom view on a Citroёn Xantia car front (the petrol engine of 2.0 l - for diesel engines an arrangement of components identically is shown)

1 — the Drain stopper of the pallet of a case of the engine
2 — Intermediate section of the right power shaft
3 — the Receiver of the tank of hydraulic LHM liquid
4 — the Support of the brake mechanism
5 — Nizhny the lever of a forward suspension bracket
6 — Steering draft

7 — the Drain stopper of a case of RKPP
8 — the Steering mechanism
9 — the Pipe of system of production of the fulfilled gases
10 — the Forward stabilizer of cross-section stability
11 — the Back support of the power unit
12 — the Pump of hydraulic system LHM

The typical bottom view on a Citroёn Xantia car back (all models)

1 — the Proof-reader of height of a back suspension bracket
2 — the Proof-reader of height of a back suspension bracket
3 — the Connecting bar of a back suspension bracket
4 — the Stabilizer of cross-section stability
5 — Fuel and brake lines

6 — the Hydraulic block of a back suspension bracket
7 — the Longitudinal lever of a back suspension bracket
8 — the Receiver of the tank of hydraulic LHM liquid
9 — the Exhaust silencer with an exhaust pipe
10 — the Holder of a spare wheel

General information

This Head was made to help on purpose to the owner of the car to support the vehicle in a condition of the maximum readiness for operation, receiving from it effective return with observance of requirements to profitability and safety.

At the beginning of Head the schedule of routine maintenance of the car is provided. The sections devoted to a detailed statement of an order of performance of each of procedures of service separately below are offered. Descriptions of visual checks, adjustments, procedures of removal and installation of components are included in a material of sections, and also various good advice and recommendations. Given above an illustration with the image of types of an impellent compartment, suspension brackets and a steering will help the reader to deal with placement on the car of components subject to service.

Serving the car according to the kilometrazhno-time schedule, and following the detailed recommendations provided below, the reader will receive the accurate action program, capable to provide long duration and reliability of service of his vehicle. Remember that this program is made on a complex basis and performance only with neglect others will not lead its separate points to desirable result.

In process of performance of service of the car the reader will soon be convinced that many procedures can, and should, to be united in the general groups in view of similarity of the nature or proximity of an arrangement of components. For example, if the car for any reason is lifted over the earth, it is necessary to use a case and at the same time to check a condition of components of system of production of the fulfilled gases, a suspension bracket and a steering.

The first step in vehicle service always is self-preparation of the performer of works. Attentively familiarize with a material of the present Chapter, then make the list of components needing attention, prepare the necessary tool and outline the short plan of the forthcoming works. In case of emergence resistant to solution of problems address for the help to specialists of car-care center.