|
Citroen Xantiasince 1993 of releaseRepair and car operation |
|
Citroen Xantia + Introduction + Operation manual + Routine maintenance + engine Repair + Systems of cooling, heating + Power supply system and release - Engine electric equipment - Start and charge systems Diagnostics of malfunctions of electric equipment Check of a condition and battery charging Removal and installation of the storage battery Check of serviceability of functioning of system of a charge Removal, installation and adjustment of a tension of a belt of a drive of the generator Removal and generator installation Dismantling and generator assembly, check of a condition of internal components Check of serviceability of functioning of components of system of start Removal and starter installation Check of serviceability of functioning and starter repair Removal and installation of the switch of ignition Removal and installation of the sensor switch of a control lamp of pressure of oil Removal and installation of the sensor of level of impellent oil Removal and installation of the sensor of temperature of impellent oil + ignition System - petrol models + preheat System - diesel models + Coupling + Transmission + Power shafts + Uniform hydraulic system + Brake system + Running gear and steering + Body and salon furnish + Onboard electric equipment + electric equipment Schemes |
Start and charge systems General information Systems of start and charge are the main components of system of electric equipment of the engine. As work of data of systems is directly connected with engine functioning, they are considered separately from other onboard electric equipment, such as lighting devices, monitors etc. to which Head Onboard electric equipment is devoted separately. Information on system of ignition of petrol models is stated in the section ignition System - petrol models. The system of preheat of diesel engines is considered in the section preheat System - diesel models. The rated voltage of onboard power supply of the car equals 12 V.Zazemleniye is organized on a negative pole. The starter is executed according to the scheme with preliminary gearing and equipped with the built-in traction relay. At engine start the plunzher of the relay moves into position and enters a leading gear wheel of a starter into gearing with a gear wreath of a flywheel till food giving on the device electromotor. The leading gear wheel of a starter is equipped with the obgonny coupling providing protection of the electromotor from a provorachivaniye at excess with turns of the engine of admissible value. Precautionary measures Detailed information on a principle of functioning and service of various components of systems is provided below in appropriate sections of Head. At refusal of any components their replacement is usually made. At service of components of systems of electric equipment it is necessary to observe special precautionary measures in order to avoid risk of failure of semi-conductor elements, and also for the purpose of prevention of receiving traumas. Starting electric equipment service, surely remove a watch, rings and other metal ornaments. Even at the disconnected battery the category of condensers by casual grounding of their plugs can lead to receiving electric shock or a strong burn. Do not allow polarity violation at battery connection. In structure of such components as the generator or electronic control units enter semi-conductor elements which can be put out of action at the wrong connection of wires. At performance of start of the engine from the external power supply, or charger connection also observe polarity of connection of wires (see appropriate section in Introduction). Never disconnect electroconducting from the battery, the generator or the diagnostic equipment at the working engine. Do not allow a provorachivaniye the engine of the disconnected generator. At all do not make stock-taking of a target signal of the generator by grounding of its plugs. Do not apply to conductivity stock-taking in a chain the ohmmeters equipped manual dynamo car. At performance of any works on service of electric equipment watch, that the negative wire was disconnected from the battery. Before use of electroarc welding without fail disconnect the battery, the generator and such components, as food/ignition ECU systems in order to avoid risk of their damage. Citroёn Xantia entering into a standard complete set an automobile audiosystem is equipped with the built-in coded blokirator providing protection of a radio tape recorder from use by thieves. Protection works even at short-term shutdown of an onboard food. Before disconnecting wires from the storage battery make sure that have a code of shutdown of a blokirator of a radio tape recorder (in more detail address to Head Onboard electric equipment). |
|