Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
- Engine electric equipment
   - Start and charge systems
      Diagnostics of malfunctions of electric equipment
      Check of a condition and battery charging
      Removal and installation of the storage battery
      Check of serviceability of functioning of system of a charge
      Removal, installation and adjustment of a tension of a belt of a drive of the generator
      Removal and generator installation
      Dismantling and generator assembly, check of a condition of internal components
      Check of serviceability of functioning of components of system of start
      Removal and starter installation
      Check of serviceability of functioning and starter repair
      Removal and installation of the switch of ignition
      Removal and installation of the sensor switch of a control lamp of pressure of oil
      Removal and installation of the sensor of level of impellent oil
      Removal and installation of the sensor of temperature of impellent oil
   + ignition System - petrol models
   + preheat System - diesel models
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes


ad6e8668

Removal and installation of the sensor of temperature of impellent oil

Removal

The sensor will screw in a forward part of the pallet of a crater of the engine.

 PERFORMANCE ORDER

1. For the purpose of ensuring access to the sensor prop up protivootkatny boots back wheels, then поддомкратьте a front of the car and establish it on props.
2. Merge impellent oil in pure capacity, screw into place a drain stopper and tighten it with demanded effort (address to Head Routine maintenance).
3. Disconnect electroconducting, then turn out the sensor from the pallet of a case and remove together with a sealing washer.

Installation

 PERFORMANCE ORDER

1. Check a condition ears, in case of need make replacement.
2. Screw the sensor on the regular place and carefully tighten. Connect electroconducting.
3. Lower the car on the earth and fill in in the engine engine oil (address to Head Routine maintenance).