Citroen Xantia

since 1993 of release

Repair and car operation

Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
- Engine electric equipment
   + start and charge Systems
   + ignition System - petrol models
   - Preheat system - diesel models
      Problem diagnostics
      Removal, check of a condition and installation of candles of an incandescence
      Removal and installation of the control unit of system of preheat
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes

Removal and installation of the control unit of system of preheat

Removal

The block is located in the left part of an impellent compartment, behind the battery and is covered with a plastic cover.

PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Give a fixing nut and remove the block.
3. Disconnect from the block basis electroconducting, then give two fixing nuts and liberate the main submitting cable and a food wire. Take the block from an impellent compartment.

Installation

Installation is made upside-down. Track correctness of connection and reliability of fastening of contact sockets.

QX4.ONLINE
S40.ONLINE
A-8.ONLINE
W124.ONLINE
RX300.ONLINE
W140.ONLINE
B3-B4.SPACE
B3B4.SPACE
A-8.SPACE