Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
- Coupling
Adjustment of a drive of coupling
Removal and installation of a cable of a drive of coupling
Removal and installation of a pedal of coupling
Removal, check of a condition and installation of assembly of coupling
Removal, check of a condition of components and installation of the mechanism of switching off of coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes
|
Adjustment of a drive of coupling
General scheme of adjustment of a cable of a drive of coupling
|
|
|
1 — the Lock-nut
2 — the Adjusting nut
|
And — the Working course of a pedal of coupling
In — the Free wheeling of a pedal of coupling |
Correctness of adjustment of a drive of coupling is checked by measurement of size of a working course of its pedal. After replacement of a driving cable its usadka is made during not less than thirty squeezings of a pedal of coupling.
|
|
|
1. Make sure that nothing got under a coupling pedal, then measure distance of the central part of its slip to the basis of a steering wheel (the pedal should be completely released) now squeeze out a pedal against the stop and repeat measurement.
2. For determination of size of a course of a pedal subtract result of the first measurement from result of the second. Compare the received value to requirements of Specifications. In case of need make the corresponding adjustment (see further).
3. Adjustment of a driving cable is made by an otpuskaniye of an adjusting rayka on the end of a cable turned to transmission (see an illustration
the General scheme of adjustment of a cable of a drive of coupling). On some models access to a lock-nut is limited, in this connection it is necessary to remove previously a sleeve of an air purifier or components of its casing (see. Head of the Power supply system and release). |
|
4. In an impellent compartment weaken a lock-nut on the end of a cable of a drive of coupling turned to transmission. Modify the provision of an adjusting nut, then squeeze out a coupling pedal ten times and repeat measurement of size of its course. Continue to act in the same order until will achieve demanded result. |
|
|
5. Make sure that the size of a free wheeling of a pedal (see an illustration
the General scheme of adjustment of a cable of a drive of coupling) does not exceed 60 mm for what measure distance from an overlay of the released pedal to the basis of a steering wheel, then lift a pedal and repeat measurement; subtract from result of the first measurement result of the second.
6. Having finished adjustment, tighten a lock-nut on the end of a driving cable. Establish components of an air purifier acting in film for the purpose of ensuring access (see. Head of the Power supply system and release). |
|
|
|
