Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
- Transmission
   - Manual box of gear shifting
      Replacement of transmission oil
      Drive of the mechanism of gear shifting - the general information and adjustment
      Removal and installation of components of a drive of gear shifting
      Replacement of epiploons
      Check of serviceability of functioning, removal and installation of the sensor switch of fires of a backing
      Removal and installation of a drive of a speedometer
      Removal and transmission installation
      Major maintenance of RKPP - the general information
   + Automatic transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes


ad6e8668

Removal and installation of components of a drive of gear shifting

Removal

 PERFORMANCE ORDER

1. Prop up protivootkatny boots back wheels, then поддомкратьте a front of the car and establish it on props.
2. Give a nut and take an axial bolt of fastening of draft of gear shifting to the basis of the lever of switching.

3. Having accurately hooked a screw-driver, liberate three drafts from the spherical hinges on transmission. Disconnect draft of switching from an axis of the cranked lever and take it from under the car.

4. Remove a plastic protective cap from a bolt of fastening of the cranked lever to a stretcher.
5. Turn out an axial bolt of the cranked lever and take it together with a washer. Remove the cranked lever with connecting draft (a switching rod) and take assembly from under the car. Remove remote and axial plugs from the central part of the cranked lever.
6. Check all components of a drive on existence of signs of wear and mechanical damages. It is necessary to give special attention to a condition of axial plugs and spherical hinges of drafts. Replace defective and worn-out components. In case of need make dismantle of the lever of gear shifting (see further).

7. Liberate a protective cover of the lever from the panel of the central console.

8. Then turn off the handle and remove a cover from the lever.

9. Give fixing nuts, remove a fixing plate, lower down the lever of a choice and take it from under the car.
10. Delay from the basis of the lever of switching the bottom protective cover, then disconnect a fixing plate of the lever and lift the top protective cover, having provided with that access to the rotary hinge of lever assembly. Check assembly components on existence of signs of wear and mechanical damages, estimate a condition of protective covers, replace defective details. In case of need the lever can be separated from the basis after removal of a lock ring.

Installation

Installation is made upside-down. Pay attention to the next moments:
   a) Before installation check correctness of installation of length of drafts of a drive of gear shifting, in case of need make the corresponding adjustment (see. A drive of the mechanism of gear shifting - the general information and adjustment);
   b) Do not forget to grease with special structure (see. Specifications) rotary hinge of the lever of switching, and also spherical hinges of drafts of a drive and axial plugs of the cranked lever;
   c) Track correctness of landing and reliability of fixing of protective covers of the lever of switching;
   d) Track observance of demanded efforts of a tightening of axial bolts of the cranked lever and the choice lever, check reliability of a joint of spherical hinges.