Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
- Transmission
- Manual box of gear shifting
Replacement of transmission oil
Drive of the mechanism of gear shifting - the general information and adjustment
Removal and installation of components of a drive of gear shifting
Replacement of epiploons
Check of serviceability of functioning, removal and installation of the sensor switch of fires of a backing
Removal and installation of a drive of a speedometer
Removal and transmission installation
Major maintenance of RKPP - the general information
+ Automatic transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes
|
Check of serviceability of functioning, removal and installation of the sensor switch of fires of a backing
Check
|
|
|
1. Management of functioning of fires of a backing is carried out by means of screwed from above in a case of transmission of the sensor switch of plunzherny type. In case of violation of functioning of fires, first of all check a condition of the corresponding safety lock.
2. For check of the sensor switch disconnect from it electroconducting. By means of an ohmmeter or a lamp sampler make sure available conductivity between sensor switch plugs at a choice to a reverse gear. At negative result of check and lack of visible defects of electroconducting of the corresponding contour it is necessary to replace actually the sensor switch. |
|
Removal
|
|
|
1. For the purpose of ensuring access to the sensor switch, depending on a model complete set, remove an inlet air line (ы) (see. Head of the Power supply system and release) and the battery with the basic pallet (see. Head engine Electric equipment). |
|
2. Disunite the electric socket, then turn out the sensor switch and remove it from a transmission case together with a sealing washer. |
|
|
Installation
|
|
|
1. Replace a sealing washer, then screw the sensor switch on the regular place in a transmission case. Tighten the sensor with demanded effort.
2. Restore initial connection of electroconducting, establish on a place and connect the battery / an inlet air line (ы). Check serviceability of operation of fires of a backing. |
|
|
|
