Citroen Xantia

1. Transfer the lever to the situation "N" (Neutral).
2. For the purpose of ensuring access to the end of a driving cable turned to transmission remove the battery with the pallet and a basic plate (see. Head engine Electric equipment). It is in addition possible to remove also inlet air line (ы) (see. Head of the Power supply system and release).
3. Having hooked a big screw-driver with a flat sting, accurately liberate a cable tip from the spherical hinge of the lever of a choice of transfers on transmission (hold the lever in the chosen situation [N]).
4. Make sure that a tip will screw on a carving of the core of a cable not less than on 5 millimeters.
5. Make sure that the selector lever, no less than the lever of a choice of transfers on transmission, are in provisions N. The tip of a cable should be combined correctly with the spherical hinge of the lever of a choice of transfers so that not to cause shift of the last at connection. In case of need make the corresponding adjustment, rotating a cable tip in the demanded direction (do not forget about the condition stipulated in the previous point). If to achieve demanded result it is not possible, for further adjustment weaken lock-nuts a crêpe of a cover of a cable on its basic arm (see an illustration Fastening of a driving cable to a spherical support of the lever of a choice of transfers on transmission). Displace nuts in the demanded direction, achieving the correct provision of a tip. Do not forget to tighten a nut.
6. Having achieved satisfactory result, strongly fix a cable tip on the spherical hinge of the lever.
7. Establish into place all components acting in film for the purpose of ensuring access.