Citroen Xantia

1. The cooler of ATF is established from above on a transmission case. For the purpose of ensuring access to assembly remove an inlet air line (ы) (see. Head of the Power supply system and release). Turn out three bolts of fastening of a basic arm of hoses, separate an arm from assembly of a cooler and shift it aside.
2. For the purpose of minimization of losses of cooling liquid by special clips or clamps press both coolers of ATF of a hose brought to assembly (see an illustration of the Detail of installation of a cooler of ATF).
3. Weaken fixing collars and disconnect both coolers of a hose brought to assembly. Prepare for collecting spilled cooling liquid. At once collect traces of the spilled liquid and rinse with cold water a cooler and surfaces adjoining to it.
4. Turn out the central bolt (see an illustration of the Detail of installation of a cooler of ATF). also remove cooler assembly about three. Remove from the central bolt the sealing ring put on it. Also remove two sealing rings, established in the basis of assembly of a cooler. All three sealing rings are subject to replacement without fail.

1. Grease new sealing rings with pure transmission liquid and establish them on the regular places on assembly (see an illustration Sealing rings of assembly of a cooler of ATF).
2. Establish cooler assembly on the seat from above on AT case. Track, that the flat edge of assembly appeared located parallel to an interfaced surface of a case. Screw the central bolt and tighten it with demanded effort.
3. Connect to a cooler hoses of an okhladitelny path, fix hoses collars and remove pressing clips/clamps.
4. Establish into place all components acting in film for the purpose of ensuring access.
5. In summary add necessary quantity of a mix of demanded structure in system of cooling and check ATF level (address to Head "Routine maintenance of the car").