Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
- Brake system
   Pumping of hydraulic system
   Replacement of hoses and tubes of a hydraulic path of brake system
   Replacement of blocks of disk brake mechanisms of forward wheels
   Replacement of blocks of disk brake mechanisms of back wheels
   Condition check, removal and installation of brake disks
   Removal, major maintenance and installation of supports of disk brake mechanisms of forward wheels
   Removal, major maintenance and installation of supports of disk brake mechanisms of back wheels
   Removal, major maintenance and installation of the valve of management
   Removal and installation of a pedal of a foot brake
   The parking brake - general information and adjustments
   Removal and installation of a control lever of the parking brake
   Removal and installation of cables of a drive of the parking brake
   Removal and installation of the sensor switch of stoplights
   System of anti-blocking of brakes (ABS) - the general information
   Removal and installation of components of system of anti-blocking of brakes
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes


ad6e8668

Removal and installation of the sensor switch of stoplights

Removal

 PERFORMANCE ORDER

1. The sensor switch is built in a rubber emphasis of a pedal of a foot brake.
2. Disconnect a negative wire from the battery.
3. Release fixing clamps and remove the bottom section of furnish of the dashboard in a driver's foot well.
4. In the top part of a pedal disunite the socket of electroconducting of the sensor switch of stoplights.
5. Liberate electroconducting from a pedal.

6. Under a pedal, give a fixing nut and remove assembly of a rubber emphasis with the sensor switch built in in it.

Installation

Installation is made upside-down. Track reliability of fixing of electroconducting on pedal assembly.