Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
- Brake system
   Pumping of hydraulic system
   Replacement of hoses and tubes of a hydraulic path of brake system
   Replacement of blocks of disk brake mechanisms of forward wheels
   Replacement of blocks of disk brake mechanisms of back wheels
   Condition check, removal and installation of brake disks
   Removal, major maintenance and installation of supports of disk brake mechanisms of forward wheels
   Removal, major maintenance and installation of supports of disk brake mechanisms of back wheels
   Removal, major maintenance and installation of the valve of management
   Removal and installation of a pedal of a foot brake
   The parking brake - general information and adjustments
   Removal and installation of a control lever of the parking brake
   Removal and installation of cables of a drive of the parking brake
   Removal and installation of the sensor switch of stoplights
   System of anti-blocking of brakes (ABS) - the general information
   Removal and installation of components of system of anti-blocking of brakes
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes


ad6e8668

Removal and installation of a pedal of a foot brake

Removal

 PERFORMANCE ORDER

1. Remove dashboard assembly (address to Head the Body and salon furnish).
2. Where it is required remove for the purpose of ensuring access an air line of system of heating of salon.
3. In the top part of a basic arm of a steering column block from a provorachivaniye an axial bolt of a pedal of a foot brake and give a nut of its fastening.
4. Carefully unhook a returnable spring. Try to remember an order of installation of a spring on pedal assembly. Remove a pedal from a basic arm.
5. Disconnect electroconducting from the sensor switch of stoplights and take a pedal from the car.

Installation

Installation is made upside-down. Track correctness of connection of a returnable spring. Do not forget to establish into place the dashboard (address to Head the Body and salon furnish).