Citroen Xantia

1. Remove a cogwheel of a cranked shaft and the oil pump (see. The repair procedures which are not demanding extraction of the engine from the car - petrol engines or the Repair procedures which are not demanding extraction of the engine from the car - diesel engines).
2. Take shatunno-piston assemblies (see. Removal of shatunno-piston assemblies). If pistons and rods do not need service, will be отболтить covers of shatunny bearings enough and to push assemblies up, having removed them from necks of a cranked shaft.
3. Measure size axial люфта a cranked shaft (see. Check of a condition of a cranked shaft). Also pass to performance of the procedures stated in the following paragraphs.

4. Turn out fixing bolts and remove the holder of an epiploon with forward (from a gas-distributing belt) an end face of the block of cylinders. At the corresponding complete set, remove also sealing laying of the holder.

5. Remove a chain of a drive of the oil pump, then remove from a pin of a cranked shaft a leading asterisk of the pump with the remote plug (at the corresponding complete set).

6. Take from the groove in a shaft pin a segment shponka. Clean a shponka together with the removed cogwheel in a reliable place.

7. Covers of radical bearings should be marked by figures with 1 on 5, in the direction from a flywheel / a driving disk. If factory marking on covers is absent, put labels independently by means of a hammer and a center punch. Measure and write down adjusting depth of a back epiploon of a cranked shaft in a cover of the radical bearing.

8. On models 1580 and 1761 of cm ³ give two bolts of fastening to the block of a cover of the central radical bearing (one from the forward party of the block, the second - with back). Take boats and remove them together with sealing washers.

9. On all models weaken fixing bolts/nuts and remove covers of radical bearings. Take the bottom loose leaves of bearings and attach them to the covers an adhesive tape. From cheeks of a cover of the second bearing remove also persistent washers. From walls of a cover of the first bearing remove rubber sealing strips (a sealant are subject to replacement without fail).

10. Carefully, take from the block a cranked shaft. Track, that the bottom loose leaves of radical bearings remained in the beds in the block. Remove and will throw out an old back epiploon of a shaft.

11. Take the top loose leaves from beds in the block of cylinders, marking them by means of an adhesive tape on compliance to bearing number. Remove the top half of persistent washers of the second bearing and combine them in a reliable place together with the bottom washers.