Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
- Power supply system and release
   - Power supply system - petrol models
      Removal and installation of assembly of an air purifier
      Removal, installation and adjustment of a cable of gas
      Removal and installation of a pedal of gas
      Unleaded fuel - the general information and use rules
      Systems of injection of fuel - the general information
      Sbrasyvaniye of pressure in a power supply system
      Removal and installation of the fuel pump
      Removal and installation of the sensor of fuel consumption
      Removal and installation of a fuel tank
      Check of a condition and adjustment of system of injection of fuel
      Removal and installation of the case of a throttle
      Removal and installation of components of Bosch Motronic 5.1 system
      Removal and installation of components of Magneti-Marelli 8Р system
      Removal and installation of the inlet pipeline
      Removal and installation of a final collector
   + the Power supply system - diesel models
   + Systems of decrease in toxicity and production of the fulfilled gases
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes


ad6e8668

Removal and installation of assembly of an air purifier

Removal

 PERFORMANCE ORDER

1. Weaken a collar (ы) and disconnect a ventilating hose (and) from the air sleeve connecting an air purifier to the case of a throttle. Afterwards release fixing collars, disconnect an air sleeve from an air purifier and remove it from the car. Where it is required, remove from the throttle case a rubber sealing ring.
2. Release two clamps, turn out two screws in a forward part of a cover of a head of cylinders and uncover an air purifier a head of cylinders. Take filtering element.
3. For removal of an inlet air line give a bolt of fastening of its back section to an end face of a head of cylinders, then weaken a fixing collar and disconnect a sleeve from a cover of a head of cylinders. Turn out a bolt of fastening of forward section of an air line to a cross-section beam and take a sleeve from an impellent compartment.

Installation

Installation is made upside-down. Track correctness of connection and reliability of fastening of all hoses and sleeves.