Citroen Xantia

since 1993 of release

Repair and car operation


Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
- Onboard electric equipment
   Search of causes of failures of electric equipment
   Safety locks and the relay - the general information
   Removal and installation of switches
   Replacement of lamps of external lighting and alarm devices
   Replacement of lamps of internal lighting devices
   Removal and installation of external lighting and alarm devices
   Adjustment of optical axes of head headlights
   Removal and installation of an instrument guard
   Removal and installation of components of an instrument guard
   Removal and installation of hours
   Removal and lighter installation
   Alarm system “do not forget to switch off lighting devices” - the general information
   Removal and installation of a horn of a horn
   Removal and installation of a driving cable of the speedometer/sensor of speed
   Removal and installation of the lever of a screen wiper
   Removal and installation of the electromotor and drafts of a drive of a cleaner of a windscreen
   Removal and installation of the electromotor of a drive of a back screen wiper
   Removal and installation of components of system of washing of glasses and lenses of head block headlights
   Removal and radio tape recorder installation
   Removal and installation of loudspeakers
   Removal and installation of the aerial of a radio receiver
   Anticreeping system - the general information
   Safety cushion - the general information, precautionary measures and system deactivation
   Removal and installation of components of a safety cushion
   Diagnostics of systems of electronic control
+ electric equipment Schemes

ad6e8668

Removal and installation of components of system of washing of glasses and lenses of head block headlights

The tank of washing liquid

Removal

For the purpose of minimization of losses of liquid originators of the real Management recommend to devastate previously the tank at least half.


 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Remove a front bumper (address to Head the Body and salon furnish).
3. Get under the tank suitable drain capacity, then disconnect from the pump (ов) electroconducting and a hose (and). Lower from the tank the liquid remains.

4. Disconnect from the tank jellied and ventilating hoses.

5. Turn out two bolts of an assembly bracket of fastening of the tank to a car body, turn a bracket down and remove the tank.

Installation

Installation is made upside-down. Before installation to the place of a bumper make sure of reliability of fastening of electroconducting and hoses.

The pump of supply of washing liquid

Removal

Before pump removal (ов) it is necessary to empty the tank of washing liquid, or to take the appropriate measures, having prepared for collecting spilled liquid.


 PERFORMANCE ORDER

1. Prop up protivootkatny boots back wheels, then поддомкратьте a front of the car and establish it on props. Remove the right forward wheel.
2. Disconnect electroconducting, accurately liberate the pump from the landing plug and take it through a wheel arch.
3. Disconnect a hose (and) and remove the pump.

Installation

Installation is made upside-down.

Nozzle of washing of a windscreen

Removal

 PERFORMANCE ORDER

1. Open a cowl and liberate from its bottom party a nozzle of supply of liquid of washing of a windscreen. Disconnect a nozzle from a submitting tube.

Installation

At installation the hose should be connected to a nozzle before landing of the last in a cowl. Nozzle adjustment by means of a hairpin can be in case of need made. The submitted stream of washing liquid should get to area, is slightly higher than the central point of a site of glass wiped by a screen wiper.

Nozzle of washing of back glass

The nozzle is built in the screen wiper lever.