Citroen Xantia

since 1993 of release

Repair and car operation


Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
- Power supply system and release
   + the Power supply system - petrol models
   - Power supply system - diesel models
      Power supply system filling with fuel and removal from it air jams
      Check and adjustment of the maximum turns of the engine
      Removal, installation and adjustment of the thermosensitive sensor of turns of fast idling
      The electromagnetic locking valve - general information, removal and installation
      Removal and TNVD installation
      Methods of check of installation of the moments of injection of fuel
      Check and adjustment of the moments of injection (TNVD Lucas)
      Check and adjustment of the moments of injection (TNVD Bosch)
      Check of serviceability of functioning, removal and installation of nozzles of injection of fuel
      Removal, installation and adjustment of a cable of gas
      Removal and installation of a pedal of gas
      Removal and installation of assembly of a toplivozabornik with the fuel consumption sensor
      Removal and installation of a fuel tank
      Removal and installation of the inlet pipeline and final collector
      Turbokompressor - general information and precautionary measures
      Removal and turbokompressor installation
      Check of a condition and regenerative repair of a turbokompressor
      Removal and installation of the built-in cooler of a turbokompressor
      Removal and installation of an air purifier and accompanying components
   + Systems of decrease in toxicity and production of the fulfilled gases
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes

ad6e8668 !

Removal, installation and adjustment of a cable of gas

Removal

 PERFORMANCE ORDER

1. In impellent, manipulating operating TNVD lever, disconnect from it the core of a cable of gas.

2. Liberate a cable cover from the plug through passage in a pump arm.

3. Liberate a cable from the remained intermediate clamps and arms in an impellent compartment. Try to remember a route of its laying precisely.
4. In salon of the car release clamps and remove the bottom felt section of furnish of the dashboard in a driver's foot well.
5. Having turned on a turn quarter counter-clockwise, release a clamp and uncover the assembly block of safety locks. Having released the remained clamps, remove the bottom felt cover established under the dashboard from the driver's party of the car.
6. Release a clamp and disconnect the cable core from a gas pedal.
7. Liberate a cable cover from an arm on a gas pedal.
8. Accurately push a cable through the plug through passage from an impellent compartment in salon and remove it from the car.

Installation

Installation is made upside-down. Track observance of the correct route of laying of a cable. In summary execute its adjustment (see further).

Adjustment

 PERFORMANCE ORDER

1. Remove from a cover of a cable of gas a spring clamp. Make sure that the operating TNVD lever is pressed to an emphasis, then carefully pull a cable from the plug through passage, completely choosing a weak point of its core.
2. Having fixed a cable this situation, establish a spring clamp in the last from visible flutes in front of the rubber plug through passage and a washer. After a cover otpuskaniye the core of a cable should receive the minimum weak point.
3. Ask the assistant to squeeze out a pedal of gas and make sure of completeness of moving of the operating TNVD lever. At a pedal otpuskaniye the lever should come back to a starting position, nestling on an emphasis.