Citroen Xantia

since 1993 of release

Repair and car operation


Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
- Power supply system and release
   + the Power supply system - petrol models
   - Power supply system - diesel models
      Power supply system filling with fuel and removal from it air jams
      Check and adjustment of the maximum turns of the engine
      Removal, installation and adjustment of the thermosensitive sensor of turns of fast idling
      The electromagnetic locking valve - general information, removal and installation
      Removal and TNVD installation
      Methods of check of installation of the moments of injection of fuel
      Check and adjustment of the moments of injection (TNVD Lucas)
      Check and adjustment of the moments of injection (TNVD Bosch)
      Check of serviceability of functioning, removal and installation of nozzles of injection of fuel
      Removal, installation and adjustment of a cable of gas
      Removal and installation of a pedal of gas
      Removal and installation of assembly of a toplivozabornik with the fuel consumption sensor
      Removal and installation of a fuel tank
      Removal and installation of the inlet pipeline and final collector
      Turbokompressor - general information and precautionary measures
      Removal and turbokompressor installation
      Check of a condition and regenerative repair of a turbokompressor
      Removal and installation of the built-in cooler of a turbokompressor
      Removal and installation of an air purifier and accompanying components
   + Systems of decrease in toxicity and production of the fulfilled gases
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes

ad6e8668

Removal and installation of an air purifier and accompanying components

Removal

Air purifier (models without a turbo-supercharging)

 PERFORMANCE ORDER

1. Release collars of fastening of an air purifier to an air sleeve of the inlet pipeline. Where it is required, turn out a bolt of fastening of a sleeve. Disconnect a sleeve and remove it from the engine. On D9B engines remove about sealing laying from an air distributor casing.
2. Turn out a bolt of fastening of an inlet air line to a cross-section beam, then liberate a sleeve from clamps on a wall of an air purifier and remove it from the car.
3. Give fixing bolts and remove air purifier assembly with a basic arm from the car.

Air purifier (models with a turbo-supercharging)

 PERFORMANCE ORDER

1. Release collars of fastening of an air purifier to an air sleeve of the inlet pipeline. give a bolt of fastening of a sleeve. Take assembly of an air sleeve from an impellent compartment. Remove the sealing laying, the sleeves established from both parties.
2. Turn out a bolt of fastening of an inlet air line to a cross-section beam, then liberate a sleeve from clamps on a wall of an air purifier and remove it from the car.
3. Turn out fixing bolts and take an air purifier from an impellent compartment.

Air distributor casing (models without a turbo-supercharging with the D9B engine)

 PERFORMANCE ORDER

1. Disconnect an air hose and a hose of ventilation of a case from a forward part of a casing of the air distributor.

2. Turn out two bolts of fastening of a casing to forward assembly brackets. Remove remote washers.

3. Turn out four bolts of fastening of a casing of the air distributor to the inlet pipeline. Remove washers.

4. Remove an air distributor casing from the inlet pipeline. remove sealing laying (and).

Installation

Installation is made upside-down. Do not forget to check a condition and, in case of need, to make replacement of sealing laying.