Citroen Xantia

1. Prop up back wheels of the car, then поддомкратьте a front of the car and establish it on props. Remove the corresponding forward wheel.
2. Weaken and partially unscrew a nut of a spherical finger of fastening of a tip of steering draft on stupichny assembly, then liberate a finger from a reception nest by means of a divider of spherical support. Remove a nut.
3. If the tip is used further, mark its situation to a draft bar.
4. Fix a draft bar from a provorachivaniye and give on a half of turn a lock-nut.
5. Having precisely counted quantity of turnovers of a carving, turn out and remove from draft its tip.
6. Count and write down quantity of naked rounds of a carving from an end face of the spherical hinge of a tip to a lock-nut. Check serviceability of a condition of a tip, its protective cover, a shaft and a carving of a spherical finger. In case of identification of the hinge indicating wear люфта or mechanical damages make replacement.
7. Carefully clean a carving on a draft bar.

1. At installation of a new tip transfer on it an old lock-nut, having screwed it so that that the quantity of naked rounds of a carving corresponded to the value fixed in the course of dismantle.
2. Screw a tip in draft on the quantity of turns counted in the course of dismantle. Thus the lock-nut of a tip should appear otstoyashchy from an emphasis on a turn quarter (be verified with the marking put earlier).
3. Fix a tip in stupichny assembly and screw a new nut of a spherical finger, having tightened it with demanded effort.
4. Establish a wheel, then lower the car on the earth and tighten wheel bolts with demanded effort.
5. Check corners of installation of forward wheels (see. Corners of installation of wheels - the general information, check and adjustment of convergence of forward wheels), then strongly tighten a lock-nut of a tip of steering draft.