Removal and installation of the proof-reader of height of a road gleam of a forward suspension bracket
Removal
|
|
At the corresponding complete set new sealing couplings of shtutserny sockets of hydraulic tubes be required. |
|
|
|
1. Dump pressure in hydraulic system (see. Head Uniform hydraulic system).
2. To Poddomkratta the car also establish it on props
3. Mark the adjusting provision of hydraulic tubes, then disconnect them from assembly of the proof-reader of a road gleam. Get under assembly of the proof-reader suitable drain capacity and disconnect hydraulic tubes. At once закупорьте the open ends of tubes and unions of their connection for the purpose of minimization of losses of liquid and in order to avoid hit in dirt system. |
|
4. Turn out bolts of fastening of the proof-reader and liberate driving rods from the executive lever of assembly, remembering adjusting provisions of components. Take assembly of the proof-reader from under the car.
1 — two hydraulic tubes
2 — fastening bolts |
|
|
Installation
Regenerative repair of the proof-reader of height of a road gleam is not obviously possible. In case of a device exit out of operation make replacement it assembled.
Installation is made upside-down. Pay attention to the next moments:
a) Track correctness of connection and reliability of fastening of hydraulic tubes, at the corresponding complete set do not forget to replace sealing couplings of shtutserny sockets;
b) Do not forget to grease spherical hinges of driving rods before connection them to the executive lever of the proof-reader;
c) After car lowering on the earth tighten spuskny the gate of a regulator of pressure and transfer a control lever a suspension bracket to the situation "Maximum";
d) Check level of hydraulic liquid, in case of need make the corresponding adjustment (address to Head Routine maintenance);
e) In summary check installation of a road gleam (see. Check of installation and adjustment of a road gleam).
|
