Citroen Xantia

since 1993 of release

Repair and car operation


Citroen Xantia
+ Introduction
+ Operation manual
- Routine maintenance
   + Weekly checks
   - Routine maintenance of the car - petrol models
      Regular service
      Replacement of impellent oil and oil filter
      Check of a condition of hoses, and identification of sources of leaks
      Check of adjustment of coupling
      Check of level of ATF
      Suspension bracket and steering drive
      Check of a condition of protective covers of power shafts
      Reading of memory of the block of self-diagnostics
      Replacement of the dust removal filter (model with To/in)
      Check of a condition of a coolant of central air of air
      Replacement of spark plugs
      Check of a condition of system of ignition
      Check and adjustment of turns and quality of a mix of idling
      Check of serviceability of functioning of systems of decrease in toxicity of the fulfilled gases
      Check of a condition and replacement of a belt of a drive of auxiliary units
      Greasing of the mechanism of a drive of switching off of coupling
      Check of a condition of blocks of brake mechanisms of lobbies and back wheels
      Check of serviceability of functioning and adjustment of the parking brake
      Trial runs
      AT transmission liquid replacement
      Greasing of locks and loops
      Replacement of a filtering element of an air purifier
      Check of level of transmission oil (model with RKPP)
      Replacement of the fuel filter
      Replacement of hydraulic LHM liquid and returnable filter
      Check of a condition of brake supports, disks and hydraulic hoses
      Replacement of a belt of a drive of GRM
      Replacement of cooling liquid
   + Routine maintenance of the car - diesel models
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes

ad6e8668

Check of a condition of blocks of brake mechanisms of lobbies and back wheels

THROUGH EACH 30 000 KM (18 000 MILES) RUN

 PERFORMANCE ORDER

1. To Poddomkratta the car also establish it on props. Remove lobbies and back wheels.

2. The visual assessment of residual thickness of frictional overlays of blocks can be made through a special observation port in the support case. For strict check of a condition of blocks they should be taken from a support and are cleared. In parallel it is necessary to make check of a condition of both parties of a brake disk and to make sure of serviceability of functioning of a support (address to Head Brake system in more detail).

3. In summary establish to the place of a wheel and lower the car on the earth. Tighten wheel bolts with demanded effort.