Citroen Xantia

since 1993 of release

Repair and car operation

Citroen Xantia
+ Introduction
+ Operation manual
- Routine maintenance
   + Weekly checks
   - Routine maintenance of the car - petrol models
      Regular service
      Replacement of impellent oil and oil filter
      Check of a condition of hoses, and identification of sources of leaks
      Check of adjustment of coupling
      Check of level of ATF
      Suspension bracket and steering drive
      Check of a condition of protective covers of power shafts
      Reading of memory of the block of self-diagnostics
      Replacement of the dust removal filter (model with To/in)
      Check of a condition of a coolant of central air of air
      Replacement of spark plugs
      Check of a condition of system of ignition
      Check and adjustment of turns and quality of a mix of idling
      Check of serviceability of functioning of systems of decrease in toxicity of the fulfilled gases
      Check of a condition and replacement of a belt of a drive of auxiliary units
      Greasing of the mechanism of a drive of switching off of coupling
      Check of a condition of blocks of brake mechanisms of lobbies and back wheels
      Check of serviceability of functioning and adjustment of the parking brake
      Trial runs
      AT transmission liquid replacement
      Greasing of locks and loops
      Replacement of a filtering element of an air purifier
      Check of level of transmission oil (model with RKPP)
      Replacement of the fuel filter
      Replacement of hydraulic LHM liquid and returnable filter
      Check of a condition of brake supports, disks and hydraulic hoses
      Replacement of a belt of a drive of GRM
      Replacement of cooling liquid
   + Routine maintenance of the car - diesel models
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes

Check of level of transmission oil (model with RKPP)

On some models the otpuskaniye of a jellied/control stopper of a case of RKPP is made by means of a special prutkovy key of square section. Similar keys always it is possible to get in firm Citroёn company service centers.

PERFORMANCE ORDER

1. Park the car on an equal horizontal platform, whenever possible with a firm covering. Check of level of transmission oil should be made before the trip first in the present day, or not less than 5 minutes later after engine switching off. If to make check right after a car stop, the part of oil will appear distributed on surfaces of internal components of a transmission and for accuracy of measurement it will be impossible to be charged. 2. Release fixing clamps and uncover access a loker of an arch of the left forward wheel. At the corresponding complete set it is necessary to remove also protection of a case.
3. Carefully wipe a jellied/control stopper and a surface of a case of RKPP adjoining to it.
4. Turn out a stopper, wipe it and replace a sealing washer.
5. Level of oil should reach the bottom cut of a jellied/control opening. A small amount of liquid usually accumulates under a stopper and follows at extraction of the last from an opening that at all is not a sign of correctness of filling of a box. For check of level wait the terminations of its effluence, then start to fill in through an opening the fresh. Continue liquid filling until it will not start to follow too much openings. It is possible to consider level of liquid given to norm when the effluence of its surplus will stop. Use for correction of level only transmission liquid of a demanded grade (see. Specifications).
6. Transmission filling with transmission oil is among enough troublesome procedures. Besides the other it is necessary to remember that oil distribution on internal cavities of RKPP occurs to a certain temporary delay that it is necessary to consider at intermediate checks of level. Having finished correction of level of oil, make on the car a short trip during which oil should be distributed finally in a transmission. Then muffle the engine and repeat check. 7. Remember that check of level of transmission oil should be made on the car established in strictly horizontal situation. Prepare suitable drain capacity for collecting following surplus. 8. Having finished correction of level of oil, replace a sealing washer and tighten a stopper with demanded effort. Carefully collect the spilled oil, then establish into place an access cover, having reliably fixed it clamps.