Citroen Xantia

since 1993 of release

Repair and car operation

Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
- Engine repair
   + the Repair procedures which are not demanding extraction of the engine from the car - petrol engines
   - The repair procedures which are not demanding extraction of the engine from the car - diesel engines
      Measurement of kompressionny pressure and engine check on tightness
      Fixing cranked / distributive shaft and TNVD for the purpose of prevention of casual hit of valves in contact to pistons in the course of performance of procedures of service of the car
      Removal and installation of a cover of a head of cylinders
      Removal and installation of a pulley of a cranked shaft
      Removal and installation of covers of a gas-distributing belt
      Belt of a drive of GRM - the general information, removal, check of a condition and installation
      Removal and installation of cogwheels of a belt of a drive of GRM
      Removal and installation of components of the right support of the power unit and natyazhitel of a gas-distributing belt
      Removal and installation of an intermediate roller of a gas-distributing belt
      Removal, check of a condition and installation of a camshaft and pushers of valves
      Check and adjustment of klapanny gaps
      Removal and installation of a head of cylinders
      Removal and installation of the pallet of a case
      Removal, check of a condition and installation of the oil pump with a driving chain
      Replacement of epiploons
      Sensors of level, pressure and temperature of impellent oil - the general information
      Removal, check of a condition and flywheel installation / driving disk
      Check of a condition and replacement of support of a suspension bracket of the power unit
      Removal and installation of a maslookhladitel
   + Removal and major maintenance of the engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes

Removal and installation of a pulley of a cranked shaft

See. The repair procedures which are not demanding extraction of the engine from the car - petrol engines, the section Removal and installation of a pulley of a cranked shaft. Originators of the real Management recommend to make replacement of a fixing bolt without fail, regardless of its condition.

If the engine is not taken from the car and there is no possibility of use of brakes, remove a starter and block a flywheel by means of the special tool.