Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
- Engine repair
   - The repair procedures which are not demanding extraction of the engine from the car - petrol engines
      Check of kompressionny pressure in cylinders
      Fixing cranked / distributive shaft for the purpose of prevention casual in the course of performance of procedures of service of the car
      Removal and installation of a cover of a head of cylinders
      Removal and installation of a pulley of a cranked shaft
      Removal and installation of covers of a gas-distributing belt
      Belt of a drive of GRM - the general information, removal and installation
      Removal, check of a condition and installation of a natyazhitel and cogwheels of a gas-distributing belt
      Epiploon replacement (ов) camshaft
      Removal, check of a condition and installation of a camshaft and pushers of valves
      Check and adjustment of klapanny gaps
      Removal and installation of a head of cylinders
      Removal and installation of the pallet of a case of the engine
      Removal, check of a condition and installation of the oil pump
      Removal and installation of a maslookhladitel (model of 2.0 l)
      Replacement of epiploons of a cranked shaft
      Removal, check of a condition and flywheel installation / driving disk
      Check of a condition and replacement of support of a suspension bracket of the power unit
   + the Repair procedures which are not demanding extraction of the engine from the car - diesel engines
   + Removal and major maintenance of the engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes


ad6e8668

Removal and installation of a pulley of a cranked shaft

Removal

 PERFORMANCE ORDER

1. Remove a belt of a drive of auxiliary units (address to Head Routine maintenance).

2. For fixing of a cranked shaft during an otdavaniye of a bolt of fastening of a pulley include the 4th transfer and ask the assistant to squeeze out a foot brake firmly. If the engine is removed from the car, block a gear wreath of a flywheel by means of the special adaptation.

Do not try to fix at all a shaft by a core prodevaniye in a blocking opening of a pulley (see. Fixing cranked/distributive shaft for the purpose of prevention casual in the course of performance of procedures of service of the car)! If the core is already inserted, temporarily take it.

3. Turn out a fixing bolt, throw off a washer and remove a pulley from a pin of a cranked shaft. If the pin, or a segment shponka (depending on a complete set) is planted freely, take him / her and clean in a reliable place. If the pulley is planted on a shaft pin too densely, use a suitable stripper.



Installation

 PERFORMANCE ORDER

1. Make sure available on the place and reliability of landing segment шпонки / a landing pin, then put on a pulley a pin of a cranked shaft.
2. Carefully smooth out a carving part of a fixing bolt, then grease it with fixing hermetic of the Loctite type.
3. Screw a bolt (do not forget about a washer) and tighten it with demanded effort, holding a cranked shaft from a provorachivaniye in the same way to which resorted at an otdavaniye.
4. Establish into place a belt of a drive of auxiliary units (address to Head Routine maintenance).