Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
- Engine repair
   - The repair procedures which are not demanding extraction of the engine from the car - petrol engines
      Check of kompressionny pressure in cylinders
      Fixing cranked / distributive shaft for the purpose of prevention casual in the course of performance of procedures of service of the car
      Removal and installation of a cover of a head of cylinders
      Removal and installation of a pulley of a cranked shaft
      Removal and installation of covers of a gas-distributing belt
      Belt of a drive of GRM - the general information, removal and installation
      Removal, check of a condition and installation of a natyazhitel and cogwheels of a gas-distributing belt
      Epiploon replacement (ов) camshaft
      Removal, check of a condition and installation of a camshaft and pushers of valves
      Check and adjustment of klapanny gaps
      Removal and installation of a head of cylinders
      Removal and installation of the pallet of a case of the engine
      Removal, check of a condition and installation of the oil pump
      Removal and installation of a maslookhladitel (model of 2.0 l)
      Replacement of epiploons of a cranked shaft
      Removal, check of a condition and flywheel installation / driving disk
      Check of a condition and replacement of support of a suspension bracket of the power unit
   + the Repair procedures which are not demanding extraction of the engine from the car - diesel engines
   + Removal and major maintenance of the engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes


ad6e8668

Removal and installation of a maslookhladitel (model of 2.0 l)

Removal

 PERFORMANCE ORDER

1. Cock the parking brake, then поддомкратьте a front of the car and establish it on props.
2. Empty cooling system (address to Head Routine maintenance). Alternatively, press hoses of an okhladitelny path directly over a maslookhladitel and prepare for collecting spilled cooling liquid.
3. Get suitable drain capacity under the oil filter. By means of a special key turn on and remove the oil filter and merge from it oil in the prepared capacity. The damaged or deformed filter is subject to replacement. In view of insignificant cost and importance of the influence rendered on efficiency of return of the engine, originators of the real Management recommend to make replacement of the oil filter each time at its removal.
4. Release fixing collars and disconnect hoses from a maslookhladitel.

5. Turn out a fastening bolt маслоохладителя / the oil filter to the block of cylinders and remove assembly from the engine. Pay attention to an arrangement of a directing groove on a flange of a maslookhladitel, - it should sit down on a reciprocal ledge on the block. The sealing ring of a maslookhladitel is subject to replacement without fail.
And — the Fixing bolt
In — the Directing groove of assembly маслоохладителя / the oil filter

Installation

 PERFORMANCE ORDER

1. Lay a new sealing ring in a flute from the back party of a maslookhladitel and press assembly of the last to the regular place on the block of cylinders.
2. Track, that the directing groove got on a reciprocal ledge on the block, then screw the fixing block and reliably tighten it.
3. Establish the oil filter, then lower the car on the earth and make correction of level of impellent oil (address to Head Routine maintenance).
4. Add in cooling system necessary amount of cooling liquid (address to Head Routine maintenance). Start the engine and check a maslookhladitel on existence of signs of leaks.