Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
- Engine repair
- The repair procedures which are not demanding extraction of the engine from the car - petrol engines
Check of kompressionny pressure in cylinders
Fixing cranked / distributive shaft for the purpose of prevention casual in the course of performance of procedures of service of the car
Removal and installation of a cover of a head of cylinders
Removal and installation of a pulley of a cranked shaft
Removal and installation of covers of a gas-distributing belt
Belt of a drive of GRM - the general information, removal and installation
Removal, check of a condition and installation of a natyazhitel and cogwheels of a gas-distributing belt
Epiploon replacement (ов) camshaft
Removal, check of a condition and installation of a camshaft and pushers of valves
Check and adjustment of klapanny gaps
Removal and installation of a head of cylinders
Removal and installation of the pallet of a case of the engine
Removal, check of a condition and installation of the oil pump
Removal and installation of a maslookhladitel (model of 2.0 l)
Replacement of epiploons of a cranked shaft
Removal, check of a condition and flywheel installation / driving disk
Check of a condition and replacement of support of a suspension bracket of the power unit
+ the Repair procedures which are not demanding extraction of the engine from the car - diesel engines
+ Removal and major maintenance of the engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes
|
Removal and installation of covers of a gas-distributing belt
Removal
L models 1.6 and 1.8
Top cover
|
|
|
1. Release clamps in the top part of a cover and liberate from them fuel hoses.
2. Turn out two fixing bolts in the basis of a cover and take the last from an impellent compartment. |
|
Central cover
|
|
|
1. Turn out two fixing bolts, located directly under a support arm.
2. Shift a cover up, for removal from the directing pins located in the basis.
3. Take a cover from an impellent compartment. |
|
Bottom cover
|
|
|
1. Remove a pulley of a cranked shaft (see. Removal and installation of a pulley of a cranked shaft).
2. Remove the central cover (see above).
3. Turn out two fixing bolts and remove the bottom cover from the engine. Pay attention that on some models it is necessary previously отболтить and to remove assembly of a natyazhitel of an auxiliary driving belt. |
|
Models of 2.0 l
Top cover
|
|
|
1. Release clamps in the top part of a cover and liberate from them fuel hoses. |
|
2. Turn out two fixing bolts. |
|
|
3. Take a cover from an impellent compartment, having pulled it up. |
|
|
Bottom cover
|
|
|
1. Remove a pulley of a cranked shaft (see. Removal and installation of a pulley of a cranked shaft). |
|
2. Turn out three fixing bolts and remove the bottom cover of a gas-distributing belt from the engine. |
|
|
3. Pay attention that on some models it is necessary previously отболтить and to remove assembly of a natyazhitel of an auxiliary driving belt. |
|
|
Installation Installation is made as it should be, the return to a dismantle order. Track correctness of placement of covers and reliability of a tightening of fixture (see. Specifications).
|
|
