Citroen Xantia

since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
- Body and salon furnish
   Care of components of a body and car bottom
   Care of an upholstery and salon carpets
   Repair of insignificant damages of body panels
   Repair of seriously damaged body panels
   Removal and installation of a front bumper
   Removal and installation of a rear bumper
   Removal, installation and cowl adjustment
   Removal and installation of a driving cable of an otpuskaniye of the lock of a cowl
   Removal and installation of locks of a cowl
   Removal, installation and adjustment of doors
   Removal and installation of panels of an internal upholstery of doors
   Removal and installation of door handles and lock components
   Removal and installation of regulators of window regulators of door windows
   Removal, installation and adjustment of a door of a back and its telescopic emphasis
   Removal and installation of components of the lock of a door of a back
   Removal and installation of components of the uniform lock
   Removal and installation of components of the electric drive of door window regulators
   Removal and installation of door rear-view mirrors and accompanying components
   Windscreen, glass of a door of a back and the other fixed glasses - the general information
   The top hatch - the general information
   External body furnish
   Removal and installation of seats
   Removal and installation of seat belts
   Removal and installation of elements of internal furnish of salon
   Removal and installation of the central console
   Removal and dashboard installation
   Control body sizes
+ Onboard electric equipment
+ electric equipment Schemes


ad6e8668

Removal, installation and adjustment of doors

Removal

 PERFORMANCE ORDER

1. On models with laid in door panels electroconducting execute the following procedures:
   a) Disconnect a negative wire from the battery;
   b) Remove the panel of an internal upholstery of a door and the sealing screen (see. Removal and installation of panels of an internal upholstery of doors);
   c) Through an opening in a doorframe disunite contact sockets of electroconducting and liberate a plait (ы) wires from all provided clamps. Try to remember a route of laying of a plait (ов);
   d) Liberate the rubber plug of a plait of wires through passage from a forward end face of a door and pass electroconducting through an opening in a frame.

2. To Otboltita from a body rack the limiter of opening of a door.

3. Ask the assistant to support a door, or prop up door sideways a jack through wooden whetstone.

4. Having made sure of reliability of fixing of a door, отболтите also take axial fingers of both loopy assemblies. Remove a door.

Installation

Installation is made upside-down. Pay attention to the next moments:
   a) Do not forget to grease axial fingers of loopy assemblies with assembly greasing;
   b) At the corresponding complete set track correctness of laying of a plait (ов) electroconductings and reliability of fastening of contact sockets;
   c) The description of procedures installation of the sealing screen and the panel of an internal upholstery of a door is provided in the section Removal and installation of panels of an internal upholstery of doors.

Adjustment

Adjustment demands from the performer of rather high qualification and certain skills, and therefore, it will be more correct to charge its performance to specialists of car-care center.