Citroen Xantia

1. Disconnect a negative wire from the battery.
2. Open a back door
3. Open hatches of access and disconnect electroconducting from assemblies of the back combined lamps built in at a door.

4. Remove clamps.
Bверху — Extraction of the central pin of a clamp
Below — Extraction of a clamp of fastening of the finishing panel of a door of a back

5. Turn out fixing screws.

6. Remove the bottom panel of furnish of a door of a back.

7. Mark the provision of heads of bolts of fastening of zamkovy assembly.

8. Turn out two fixing bolts and remove lock assembly, having disconnected from it an executive rod.

1. Execute the procedures described in subsection "Lock assembly - Removal", subitem 1 — 4.
2. At the corresponding complete set screw two fixing bolts and remove the block of the activator of the uniform lock. Having removed the servo-driver, disconnect from the lock an executive rod and electroconducting.

3. Turn out three fixing screws, take sideways the lock cylinder from a door and disconnect the remained executive rod.

4. For cylinder extraction from assembly remove a penoplastovy sealing ring, then insert a key into a keyhole and at the same time release a lock uvula of fastening of the cylinder. For a key take the cylinder.

1. Remove covers and turn out screws of fastening of the back panel of an upholstery of a luggage compartment. Remove the panel, having provided with that access to the lock drummer.

2. Unbend back edge of a carpet and turn out two bolts of fastening of the drummer. At the corresponding complete set liberate from drummer assembly the sensor switch of the anticreeping alarm system.