Removal and installation of components of the uniform lock
Electronic control unit Removal The block is located under the central console.
Installation
Installation is made upside-down.
Door activators
Activators of the uniform lock are built in zamkovy assemblies of doors (see. Removal and installation of door handles and lock components).
Activator of the lock of a door of a back
|
|
|
1. Disconnect a negative wire from the battery.
2. Open a back door.
3. Open hatches of access and disconnect electroconducting from the back combined lamps built in a door.
4. Release clamps, turn out fixing screws and remove the panel of the bottom furnish of a door of a back. |
|
5. Turn out two fixing bolts. |
|
|
6. Take the activator of the door lock, then disconnect from it electroconducting. |
|
|
7. Installation is made upside-down. |
|
The receiver of signals from a remote control
|
|
|
1. Having accurately hooked, remove the panel of a cover of the electromotor of a drive of the top hatch. |
|
|
2. Release clamps and remove the receiver of signals of the DU panel of the uniform lock from the cover panel, disconnect electroconducting. |
|
|
3. Installation is made upside-down. |
|
DU panel batteries
|
|
|
1. Turn out the small self-cut screw in a back part of assembly of the transmitter. Extend the transmitter from a back cover for the purpose of ensuring access to batteries.
2. Take batteries (try to remember their correct adjusting situation).
3. Correctly establish two new batteries, establish into place a cover and tighten саморез. |
|
|
