Citroen Xantia

1. Remove the panel of an internal upholstery of a door (see. Removal and installation of panels of an internal upholstery of doors).

2. Release the coupling screw of a collar of fastening of an executive rod, shift the handle forward and separate it from a door. Pay attention that at removal of the handle of a back door the executive rod of the button of switching off of the lock should be liberated from a door without a detachment from the handle.

3. Disconnect from the handle an executive rod of the door lock.

4. At the corresponding complete set before removal of the handle liberate an electroconducting plait from a clamp located in its top part.

1. Remove the panel of an internal upholstery and the plastic sealing screen (see. Removal and installation of panels of an internal upholstery of doors).

2. From a back end face of a door turn out three screws of fastening of zamkovy assembly. Liberate an executive rod of the internal handle from a clamp on a door for the purpose of a possibility of turn of assembly.

3. In a frame of a door disconnect from the lock an executive rod of the external handle.

4. Through an opening in a doorframe turn out the fixing screw.

5. Remove the external handle together with executive rods.

1. Remove the panel of an internal upholstery and the plastic sealing screen (see. Removal and installation of panels of an internal upholstery of doors).
2. Completely lift a windowpane.

3. Turn out the fixing screw.

3. Take from a door directing trench of a windowpane.

4. Through an opening in a doorframe turn out the screw of fastening of the external handle.
5. Remove the external handle of a door and disconnect an executive rod of the lock.

1. Open a door, then take from an access opening in its back end face (at once over the lock) the rubber plug.
2. Insert a key into the lock.
3. Pass a long screw-driver in an opening of access and wring out a lock ring of fastening of the cylinder of the lock.

4. For a key extend the lock cylinder from the external handle of a door.

1. Fill the lock cylinder on the regular place, having latched it in a lock ring.
2. Plant in an access opening in a back end face of a door the rubber plug.

1. Remove internal and external door handles (see above), then take the lock from a door assembled with executive rods, at the corresponding complete set disconnect electroconducting.

1. Remove the external handle of a door (see above).
2. In a back end face of a door turn out three screws of fastening of zamkovy assembly.
3. Liberate executive rods from clamps on a door.

4. Through an opening in a doorframe take the lock with the executive rods connected to it (try to remember adjusting position of the last). At the corresponding complete set disconnect electroconducting.